RMCS Logo Orange banner

About Our THL Lifting Loops for Lifting Sockets

THL Lifting Loops

Lifting loops THL.jpg Threaded Lifting Loops can be used with all sizes of threaded inserts. They are the most economic lifting loops and are suitable for most applications. They are not suitable for turning/pitching. They may be reused subject to the inspection procedure, detailed below, but they are not recommended for severe reuse conditions. Threaded Lifting loops should only be attached to the unit after the concrete strength has reached 15 N/mm. In some cases it may be economic and practical to leave the loops with the unit until final installation.

Threaded Lifting Loops are manufactured from high grade steel wire, swaged in a steel ferrule and finished with zinc plating. They are clearly marked with their SWL. The thread type is Rd/M, which is compatible with both metric and Rd inserts. Threaded Lifting Loops are suitable for use with inserts cast in flush with the face of the unit, or recessed by using the recess formers.

Lifting loops THL table.jpg

Lifting at an angle greater than 45 degrees is not allowed.

email RMCS Now

Featured Products

SPARTAN Precast Magnet System SPARTAN Precast Magnet System

Panelware Tiltup System Panelware Tiltup System

Rebar Spacers Rebar Spacers

Formwork Corner Fillets or Chamfers Chamfers or Corner Fillets

RMCS Fixing Pliers / Concretors Nippers Fixing Pliers / Concretors Nippers

Orange and Yellow Barrier Netting Orange & Yellow Barrier Netting

DBR-32WH Handheld Rebar Bender & Straightener Handheld Rebar Straightener Bender

DBC-16H Handheld Rebar Cutter Bender Handheld Rebar Cutter Bender

Contact us now on +27 11 310 8660 or +27 11 310 7113. You can also email us on [email protected]